Free U.S. shipping on orders of $99 or more · 3M / Oracal vinyl · gloss UV laminate · 3-year guaranteeCode 10OFFNOW = 10% off (up to $25) through Nov 30
Shop
Door BuilderYour Logo
Learn
ContactBuild my decal →

Installation Tips

Every printed decal ships with a printed instruction sheet and a link to this video. Watch it once before you start, then follow the quick checklist below. Cut vinyl lettering (letters only, with transfer tape) has its own steps further down.

Before you start

  • Wash the door and let it dry completely. The surface must be clean, dry and free of wax or polish.
  • Work in the shade, in mild temperatures, if you can.
  • Measure and mark where the decal goes with masking tape. Check that it is level and that the lettering will be easy to read from the side of the truck.
  • Have a squeegee ready (a plastic card wrapped in a soft cloth works too; one is not included in the package), plus a clean cloth and a sharp blade or pin.

Put it on, step by step

  1. Lay the decal on its backing against the door inside your tape marks. Run a strip of masking tape across the top edge so it holds like a hinge.
  2. Swing the decal up. Peel the backing away slowly and cut off the loose backing.
  3. Lower the decal toward the door without letting it touch yet. Starting in the middle, press it down with a squeegee and work outward in overlapping strokes toward each edge.
  4. If there is a clear transfer layer on the front, pull it back slowly on itself at a low angle, close to the surface. If part of the lettering lifts, lay it back down, squeegee that spot again and continue.
  5. Press the edges once more with a squeegee or a clean cloth. For a trapped bubble, make a tiny pinhole at its edge and push the air toward the hole.
  6. Remove the masking tape and step back to check that the decal is straight and easy to read.

Your printed instruction sheet is the final word if it ever differs from this page. For more detail, see our step-by-step guide on how to install decals on a truck door.

Cut vinyl lettering (letters only, with transfer tape)

Cut vinyl lettering has no background: each letter is cut from vinyl, and the transfer tape on top holds the whole line together so it goes on in one piece.

  1. Wash the surface and let it dry completely. It must be clean, dry and free of wax or polish.
  2. Hold the lettering in place with the transfer tape (the top layer) facing you, and run a strip of masking tape across the top edge as a hinge. Check it is level.
  3. Flip it up on the hinge and peel the backing paper off slowly. The letters stay on the transfer tape; if one stays on the backing, lay it back down, rub it and try again.
  4. Lower it back down onto the surface and press it on with a squeegee or a credit card, working from the middle out.
  5. Peel the transfer tape off slowly, folded back almost flat against itself. If a letter starts to lift with it, press it back down and rub it again before you go on.

Need a hand?

If anything looks wrong when you open the package, or a decal does not stick, contact us at info@workdecals.com. Decals are covered by our 3-year guarantee, and if one peels or comes off we send a replacement for free.